A170112, ARB AXLE & TRANS BREATHER KIT
ARB AXLE & TRANS BREATHER KIT
$69.95
Description
A170112, ARB AXLE & TRANS BREATHER KIT Click Here
Vent your Cruiser axles, transmission and transfer case up to your dash or fire wall high above the water line. Greatly reduces the chance of getting water in your driveline. Breather system looks good and serves an important purpose. Simply pop off the breather caps and slip on the included 8mm tubing. Kit comes with enough fittings to do 2 breathers. See notes below.
This
kit is intended to replace your factory breathers and contains enough fittings
and tubing to connect at least two drivetrain assemblies. More tubing and
push-in fittings can be purchased separately to connect up to four breathers.
TO ORDER ADDITIONAL FITTINGS, A170113 Click Here
FEATURES
- The
axle breather manifold is machined from billet aluminum and anodized,
making it lightweight and resistant to the elements. - The
manifold has 4 axle breather ports allowing for between 1 and 4 breather lines
to be connected. It is very compact allowing it to be installed in virtually any
location. - The
kit comes with self tapping screws, but the manifold mounting holes are large
enough to allow mounting using an M6 (1/4 inch) bolt or stud, which is the
common size in most vehicle engine bays. - The
air filter is the ARB compressor air filter, which is a splash resistant air
filter with a washable high flow sintered bronze filter cartridge. - 8mm
Polyethylene tubing is flexible, oil resistant, water resistant and heat
resistant. - 8mm
tubing has been selected over the standard 6mm tubing to improve the air flow
and reduced the chance of oil blockages in long breather lines. - The
8mm push-in fittings make the installation simple and
fast.
KIT
CONTENTS:
CONTENTS:
- Anodized Aluminum Manifold with
5 ports and 2 mounting holes
- 4 x 1/8″BSP ports for connecting
up to 4 breather lines
- 1 x 1/4″ NPT ports for the air
filter
- Air filter assembly
- 4 x 8mm-1/8″BSP push-in fittings
- 3 x 1/8″BSP plugs for plugging
unused ports
- 8m x 8mm polyethylene tubing
- 2 x self-tapping screws
- 25 x cable
ties
5 ports and 2 mounting holes
up to 4 breather lines
filter
unused ports
ties
You must be logged in to post a review.
Reviews
There are no reviews yet.